DESCRIPTION
Tile Grout is a cement-based tile grout and is suitable for interior and exterior application. It is used to fill joints between tiles or natural stones laid on walls or floors with its physical function of reducing stress within the whole wall or floor covering material. Tile Grout is integrally-coloured providing ease of installation and a durable grout for floor and wall tile application.
COMPLIED STANDARD
• TCVN 7899-2: 2008
• EN 13888: 2009
ADVANTAGES
- Exceeds requirements
- For interior and exterior use
- Polymer modified – Just add water
- For wall, floor or ceiling applications
- Helps repel most stains, dirt and grime with its water beading formula
- Is durable enough for residential and/or commercial traffic.
USES (Sanded Grout)
For grouting of:
Ceramic tile, porcelain tile
Cement tile, glass tile
Quarry tile, Slate and Other natural stone
USES (Unsanded Grout)
For grouting of:
Ceramic tile, Porcelain tile
Glass tile, Marble and Other natural stone
PREPARATION
Mortar bed should be thoroughly dry before grouting approximately 48 hours for thin bed method. Clean tile and joint surfaces thoroughly and remove all excess water.
MIXING
Use a clean mixing container and a low speed mixer. Pour clean, cool water into a container and gradually add grout while slowly mixing. Mix thoroughly to a heavy cream consistency and allow to slake for 5-10 minutes, then remix thoroughly until smooth. Some stiffening may occur before all material is used (usually within about 1 hour at room temperature).
